IDM MT200 SIP Magneto Telephone Gateway | voip gateway
IDM MT200 SIP Magneto Telephone Gateway
I Overview
The IDM MT200 SIP Magneto Telephone Gateway features a large-scale integrated circuit design. This device supports up to 4 magneto telephone lines transmitted over Ethernet. It offers the choice of either one Ethernet electrical interface or one Ethernet optical interface, with a maximum bandwidth of 100M when using either interface. The device supports WEB management for configuration, allowing changes to gateway server registration, IP address settings, and call methods via a web page.
IDM MT200 Device Image
II Features
u Large-scale integrated circuit design.
u Up to 5 Ethernet electrical ports (1 WAN + 4 LAN) or 1 Ethernet optical port + 4 Ethernet electrical ports.
u Up to 4 magneto telephone RJ11 interfaces.
u Supports SIP V1 (RFC2543) and V2 (RFC3261) standard protocols.
u Adjustable call volume via web management.
u Phone book function supporting up to 20 contact entries.
u Supports call forwarding, hotline, and do-not-disturb features.
u Power options: AC220V or DC-48V, with dual power backup.
u Web management allows configuration of WAN port settings, SIP registration, and phone registration status.
u Rack-mounted design.
III Technical Specifications
3.1 Magneto Interface Specifications
u Coupling Method: Transformer coupling with strong interference resistance.
u Impedance: Input and output impedance of 600Ω.
3.2 Ethernet Interface Specifications
u Standard: IEEE 802.3 10/100BASE-TX.
u Transmission Rate: 10/100Mbit/s auto-negotiation; default is auto-negotiation.
u Operating Mode: Full-duplex/Half-duplex; default is full-duplex.
u Rate Setting: Managed via web configuration.
u Interface Type: RJ45 connector, CAT3/5 unshielded twisted pair (MDI/MDI-X auto-sensing).
u Supports auto-negotiation, rate configuration, and duplex settings.
u Ethernet Frame Length: Standard 64–1516 bytes, up to 1516 bytes.
u Ethernet Performance Standard: RFC2544.
u Packet Loss Rate: <0.01%; Latency: ≤100μs.
3.3 Environmental Requirements
u Operating Temperature: 0℃ to 40℃ (continuous operation); -5℃ to 45℃ (short-term operation).
n Note: Short-term operation refers to continuous operation not exceeding 24 hours and not exceeding 15 days per year.
u Storage and Transport Temperature: 0℃ to 70℃.
u Relative Humidity: 95% (non-condensing).
3.4 Power Supply
u Power Modes: AC220V or DC-48V, with backup power supply.
u Power Consumption: MAG OVER ≤5W.
Typical Application Diagram